How to set up a planted tank: every step from empty glass to first fish
Place and level the tank on a stand built for its filled weight, then add hardscape, substrate, plants, a slow fill, filter, heater and a light on a 6-hour timer. Cycle for about 3 to 4 weeks, until ammonia and nitrite read zero, then add livestock gradually.
The order matters
Most setup problems come from the right things done in the wrong order: filling before the hardscape is stable, or adding fish the same week. The dry work comes first, plants go in while they are easy to reach, and livestock come last. Each step is explained after the list.
The steps in order
- Choose the spot: level, out of direct sun, and on a stand or cabinet built for the load (see tanks and cabinets).
- Work out the real water volume and the filled weight with the tank volume calculator. Then size the heater, filter and substrate from those numbers, not from the label.
- Rinse the tank, gravel, sand and hardscape in plain water, with no soap or detergent. Aqua soil is usually not rinsed, so follow the maker's instructions.
- Place the tank, check it is level in both directions, and lay the hardscape in the dry tank. Push on every stone and branch to be sure nothing rocks.
- Add the substrate, deeper at the back than at the front.
- Pour treated water in slowly onto a plate or sieve so the substrate and layout stay where you put them. Tropica fills only part-way at first.
- Plant generously, with fast growers among the slow plants you want to keep.
- Fill to the water line, still pouring gently.
- Fit the filter and heater. Let the heater sit in the water before you plug it in, then start the filter and the light on a timer set to 6 hours.
- Cycle the tank with no fish (see the cycling guide), changing water and trimming as the plants settle in.
- When ammonia and nitrite both read zero, add the first livestock, a few animals at a time.
- Work through the first-month checklist at the end of this guide.
Steps 1 and 2: position, weight and volume
Keep the tank away from direct sunlight and radiators, and put it on something sturdy. Water weighs about 1 kg per litre, and a filled tank weighs noticeably more than its water alone once glass, substrate and rock are counted: one tank-stand guide suggests adding 20 to 30% for a typical setup, and our calculator allows up to 40% for rock-heavy scapes, before the stand and equipment. A 100 litre tank therefore asks the stand to carry something like 120 to 130 kg or more. Check the stand is rated for that, and use a level in both directions before the tank goes on, because an uneven surface puts stress on the glass and silicone seams.
The real water volume is less than the label, because the water line sits below the rim and substrate and rock take up room. Our calculator estimates that this is often 15 to 25% less, and more in rock-heavy scapes; treat that as a planning estimate. Use the calculator's figure for the heater, filter and doses. The equipment sections on filtration, heating and lighting list what exists, and tools and accessories covers tweezers and scissors for planting.
Steps 3 to 5: hardscape and substrate
Design the layout with the tank empty and dry, while you can still lift and turn pieces, and test that it is stable before any substrate goes in. Rock and wood go in first. Unsupported stacking can collapse and even stress the glass, so shake each stack (see falling hardscape). For the style and shape of the layout, read the beginner aquascaping guide.
Then add the substrate, deeper at the back than at the front. The substrate calculator suggests depths for the foreground, middle and back and adds a 10% margin, because fresh aqua soil settles during the first weeks. A steep slope slumps unless a rock or branch holds it (see slumping soil slopes). Some aqua soils also release ammonia in their first weeks, which the cycling guide covers.
Steps 6 to 8: filling and planting
Treat tap water with a conditioner before or as it goes in. Chlorine fades if water stands for a few days, but chloramine does not evaporate and can take weeks to go, so a conditioner is the safe default (see chlorine and chloramine and consumables). Tropica's own start guide breaks the water jet with a plate or sieve and plants first with the water only part-filled, then tops up carefully without hitting the plants or the soil.
Remove pots and stone wool, trim long roots and divide the plants into smaller groups, as Tropica advises. Tie Java fern and Anubias to wood or rock rather than burying the rhizome. Plant a lot on day one. Fast growers such as Egeria and Limnophila soak up the nutrients algae would use, and you can remove them later once the tank settles. A floating plant or hornwort is another fast grower that can do the same job. The plant finder filters by light and CO₂ need.
Step 9: filter, heater and light
- Filter: pick gentle flow that still moves water through the whole tank, and check it with the filter flow tool. Dennerle says to wash the filter only in aquarium water, and only when the flow drops noticeably, so the bacteria are not damaged.
- Heater: keep it fully under the minimum water mark. Fluval's manual puts it at the rear near flow. Never switch it on out of water. Two makers' manuals ask for 10 to 30 minutes in the water before plugging in, and to unplug it and let it cool for 15 to 30 minutes before lifting it out. Unplug it before water changes too.
- Light: choose it for the water depth with the light finder, and run it from a timer. Start at 6 hours a day for the first 2 to 3 weeks, then raise it slowly to about 8. Maker plans differ: Tropica and Dennerle both go as high as 10 hours later, but light beyond what your plants and CO₂ can use grows algae.
- CO₂: a tank without it works if you pick suitable plants (see the low-tech guide). If you plan to inject it, read the CO₂ tool first. Tropica advises providing it from day one.
Step 10: the cycle and the first weeks of plants
A new tank has no bacteria to turn ammonia into nitrite and then nitrate, so fish added now are poisoned slowly. The cycling guide explains the fishless method. Makers and charities suggest roughly 3 to 4 weeks as a planning figure, with at least 2 weeks as the floor. Real cycles vary (one guide puts a plain fishless cycle at 4 to 6 weeks), so test instead of counting days.
While the tank cycles, plants and water need care. Maker plans differ: Tropica suggests changing 25 to 50% of the water a couple of times a week for the first 3 to 4 weeks, Dennerle 50% once a week for three weeks, and both then settle at about 25% a week. Use treated, temperature-matched water. The water change tool helps with amounts. Use little or no fertiliser at first, since Tropica notes nursery plants arrive with nutrients. Sources differ here: one holds off for 3 to 4 weeks, another starts at half dose in week 2, so begin gently and watch for pale new growth (see pale new leaves).
Expect two normal setbacks. First, crypts often melt after planting: plants grown above water in the nursery, such as Wendt's crypt, drop their old leaves and regrow, usually within a few weeks to a month (see crypt melt). Leave the roots alone. Second, a brown dusty film of diatoms often appears in the first weeks and can last a month or two. Wipe it off and keep the plants growing (see brown algae).
Steps 11 and 12: livestock and the first month
Add livestock only after ammonia and nitrite both read zero. Dennerle lets hardy animals in earlier when its bacteria starter is used, but this guide keeps to the test-based rule. Add a few animals at a time with 1 to 2 weeks between groups, as Dennerle and Aqueon both advise, so the filter can catch up, and start below your final stocking level. Feed lightly (see overfeeding), and use the tank-mates tool to check compatibility.
- Week 1: plant, fill, switch on, light at 6 hours, change 25 to 50% of the water twice (Tropica's plan). No fish. Wipe the glass if diatoms start.
- Week 2: test ammonia and nitrite, keep the water changes going, trim melted leaves, and still no fertiliser, or half the label dose at most.
- Week 3: hold the light at 6 hours until week 3 ends, then raise slowly towards 8. Watch for algae.
- Week 4: drop to a weekly water change of about 25%. Once ammonia and nitrite read zero, add the first few animals.
- After that: add fish slowly over the next weeks. Tropica calls the first 90 days the critical period, so judge the tank over months, not weeks.
Common mistakes
- Adding fish before the cycle ends. This causes new tank syndrome and an ammonia spike.
- Skipping conditioner. See chlorine and chloramine.
- Too much light for too long. It feeds algae, including green water and hair algae.
- Letting tall plants shade low ones (see plants shading plants).
- Cleaning the filter too hard or too often, which can cause a crash after filter cleaning.
Next steps
Once the tank is stable, build a weekly routine around the water change tool and the fertiliser calculator. This guide is AI-assisted and has not been reviewed by an aquarium expert. Ask an aquatic vet about any sick animal.
Keep reading
Sources
We read these pages and wrote the guide in our own words. Species, problem and tool details come from our own wiki pages linked above.
- Tropica: get the right start: Setup order, shelter from direct sun, plate when filling, plant then top up, light timer at 6 hours for 3 weeks then up to 8
- Tropica: growing-in a new aquarium: 6 hours of light for 2 to 3 weeks, 25 to 50% water changes for 3 to 4 weeks, little fertiliser, fast growers, fish after 3 to 4 weeks, CO2 from day one
- Dennerle: beginner guide part 3: About 3 weeks before animals, nitrite peak then zero, 1 to 2 weeks between groups, five-week water change and fertiliser plan, diatoms
- RSPCA: choosing an aquarium: Sturdy surface away from sun and radiators, heavy tank, filter and heater in place, fishless cycling of at least two weeks
- Fluval heater manual (A783): Wait 30 minutes before plugging in, never run out of water, cool 30 minutes before removal, placement at the rear near flow
- Marina betta heater instructions: Acclimatise 10 minutes before plugging in, unplug and cool at least 15 minutes before removal
- Physics Factbook: density of water: Water is at its maximum density of 1 g/cm3 (1 kg per litre) at 4 C, and about 0.998 at 20 C
- Tampa Bay Water: monochloramine and fish: Chloramine lasts weeks in standing water, is harmful to fish and is removed with a conditioner or activated carbon
- Aquarium Co-op: how to treat tap water: Chloramine does not evaporate; chlorine fades over days; dechlorinator for new setups
- Aquarium Lesson: low-tech lighting: 6 hours for a new setup, 7 to 8 for mature tanks, use a timer, extra light feeds algae
- Fishlab: brown algae: Diatoms are normal in new tanks and can take a month or two to clear; wiping
- Fishiverse: fishless cycling: Start with about 60 to 70% of the planned stocking after the cycle
- Wikipedia: Cryptocoryne: Crypt melt after the change from emersed to submersed growth; about 30 days to regrow
- Gensou: aquarium stand and weight guide: Water weighs 1 kg per litre; add 20 to 30% for glass, substrate and hardscape; level in both directions (a shop page, so supporting only)
- Scape Eden tank volume and substrate tools: Our own planning estimates (real water often 15 to 25% below label, filled weight up to 40% above the water's, 10% settling margin); calculated from densities, not independently sourced
- Scape Eden crypt melt and cycling records: Melt is a stress reaction and regrows from the base; cycle length of 1 to 8 weeks is from our cycling guide
- Waterbox: why level your cabinet: Uneven support stresses glass and silicone seams
- Aqueon: tips for setting up a new fish tank: Add a few fish at first and wait a week or two before adding more; test ammonia and nitrite
- Charterhouse Aquatics: setting up a freshwater aquarium: Arrange decorations before filling; cycle complete when ammonia and nitrite read 0; add small groups of fish gradually
- Aquarium Lesson: aquarium hardscape: Build and test the hardscape dry; unsupported stacking can collapse and stress the glass
- Aquarium Co-op: Cryptocoryne: Crypts from emersed farms melt; wait 3 to 4 weeks for new shoots; leave them undisturbed
How we made this
Written with AI assistance from the sources listed here and checked against them. Not yet reviewed by an expert. Report a mistake · How we write and check pages
