Wiki

Free aquarium calculator

Aquarium CO₂ calculator

Estimate the CO₂ in your planted tank from pH and KH, check your drop checker colour, and see how long a cylinder lasts at your bubble rate.

CO₂ from pH and KH

dKH

Results

Estimated CO₂23.9 ppmIn the target range
KH in ppm CaCO₃
71.4 ppm CaCO₃
A 4 dKH drop checker would likely read close to Green right now.
Why this can be wrong
This table only holds if KH comes purely from carbonate/bicarbonate buffering. Aqua soil, driftwood tannins, phosphate or nitrate buffers and some RO remineralisers all throw the maths off without changing the number you read from a test kit. Treat this as a rough cross-check, not a measurement.
A better check: the pH-drop method
Measure the tank's pH right before CO₂ starts, then again once it has been running and diffusing for a while. A drop of about 1.0 pH unit is the usual sign that CO₂ is in the working range, and it does not depend on knowing your KH.

Drop checker colour

Colour you see

Results

Colour you seeGreen15–35 ppm at a 4 dKH reference
Green
The target zone for a high-tech planted tank. Hold the bubble rate here.
It lags the tank
A drop checker lags the tank by several hours (Aquarium Science describes an average over about three hours) because the reference solution has to equilibrate through the air gap. It shows where CO₂ *was*, not where it is right now — good for a trend, not for catching a fast overdose.

Cylinder life

Fills in the CO₂ capacity from the maker's data.
kg
bubbles/s
h/day

Results

Lasts about347 daysAbout 49.6 weeks
Range
231–694 days, depending on bubble size
An estimate, not a gauge reading
This assumes about 0.0002 g of CO₂ per bubble (range 0.0001–0.0003 g) — bubble counters are not standardised, so the true value depends on yours. Weighing the cylinder is the only sure way to know how much is left.

The link and the PDF keep your numbers, so you can come back or share them.

Use these numbers

More on CO₂ equipment and the other calculators.

How this calculator works

This calculator gives three planning checks for CO₂ in an injected planted tank: a cross-check from pH and KH, a reading guide for a drop checker, and how long a cylinder should last at a given bubble rate. None of it replaces watching the fish.

The pH/KH formula

CO₂ (ppm) ≈ 3 × KH (dKH) × 10^(7 − pH)

CO₂ (ppm) ≈ 3 × KH (dKH) × 10^(7 − pH). Raising KH or lowering pH both push the estimate up, because a bigger carbonate buffer needs more dissolved CO₂ to hold a given pH.

Why it can be wrong

The formula assumes every degree of KH is carbonate/bicarbonate buffering. Aqua soil, driftwood tannins, phosphate and nitrate buffers, and some remineralisers for RO water all add or change buffering without being carbonate hardness, so the same test-kit numbers can hide a very different real CO₂ level. A digital pH pen also drifts and needs regular calibration. Use this as a rough cross-check; a drop checker or the pH-drop method (about a 1.0 pH unit drop once CO₂ has been running) tracks the tank itself rather than trusting the table.

Safe practice

  • Raise the bubble rate in small steps, at most one change a day, and watch the fish for a few days after each change.
  • Start CO₂ 1–2 hours before the lights come on and stop it about 1 hour before they go off; running it 24/7 is a common cause of overnight fish loss.
  • If fish gasp at the surface, swim erratically or crowd near the top: turn the CO₂ off, maximise surface agitation, and do a 20–30% water change with dechlorinated water.
  • Warm water (28–30 °C, common in hot climates) holds less dissolved CO₂ and oxygen than the cooler water most CO₂ guidance assumes, so keep targets a little more conservative and run extra surface agitation at night.

Sources and limits

The formula, target bands, drop-checker colours and cylinder-life assumption all come from the Scape Eden research notes on CO₂ and equipment, which are drawn from published aquascaping references. Bubble-to-gram conversion is not standardised across bubble counters; weighing a cylinder is the only sure way to know how much CO₂ is left. This tool never gives medication or dosing advice.

Embed this calculator

Free to put on your own site, blog or forum. Paste the code where the calculator should appear.

Embed code

<iframe src="https://scapeeden.com/embed/tools/co2" title="Aquarium CO₂ calculator by Scape Eden" width="100%" height="1200" style="border:0;max-width:100%" loading="lazy"></iframe><p><a href="https://scapeeden.com/tools/co2">Calculator by Scape Eden</a></p>

Optional: resize the frame to fit the calculator

<script>addEventListener("message",function(e){if(e.origin!=="https://scapeeden.com"||!e.data||e.data.type!=="scape-eden-embed-height")return;document.querySelectorAll('iframe[src^="https://scapeeden.com/embed/"]').forEach(function(f){if(f.contentWindow===e.source)f.style.height=e.data.height+"px"})})</script>

Without the resize script, give the frame at least 1200 pixels of height (taller in a narrow column).

Attribution rule: keep the “Calculator by Scape Eden” link under the frame, visible and unchanged, and do not hide the credit inside the frame. The calculators are planning estimates, not advice for a particular tank.

More calculators