Free aquarium calculator
Aquarium filter flow calculator
Turn a filter's rated flow into real flow and turnover for your tank, and see how that compares with the range planted, shrimp and fish tanks usually run at.
Your tank and filter
Results
The link and the PDF keep your numbers, so you can come back or share them.
Filters in that range
Filters in our equipment pages with a published rated flow close to the range above. Sizes differ inside each line, so open the page for the exact model.
Next steps
Size the rest of the tank, and compare filters.
How this calculator works
Enter the real water volume of your tank and the flow your filter is rated for. The calculator turns that into the number of times per hour the filter could pass the whole tank, which hobbyists call turnover, then adjusts for the fact that a filter loaded with media and pushing water uphill moves less than the box says. It finally compares the result with a turnover range for the kind of tank you keep.
Turnover
Turnover is flow divided by tank volume. A 1,000 L/h filter on a 100 L tank turns the water ten times an hour on paper. Because water goes through the filter in a loop and is not replaced in one batch, it does not mean every drop is filtered ten times an hour, only that the filter moves ten tank volumes in that time. It is a handy way to compare tanks of different sizes.
Rated versus real flow
Makers publish the flow of the pump with little or no media and almost no height to lift. Loaded with sponges, a spray bar and a few metres of hose, a canister delivers less. Independent bucket tests we recorded found about 40% and 64% of the rated figure for two Eheim canisters in a forum thread on aquaticquotient.com, and 70–84% for a third on a planted tank forum. Fluval publishes its own figure for the water that leaves the filter, 61–72% of pump output across five models. From those we use 60–80% for a clean, loaded filter. The 35–50% for a dirty or densely packed filter is our own working estimate: Aquarium Science (aquariumscience.org) advises watching real flow and cleaning when it drops noticeably, but we found no outside test that puts a percentage on a clogged filter. These are estimates for planning, marked as such wherever they are used, and your own filter may sit outside them. If you have measured the real flow with a bucket, pick that option and the estimates are skipped.
Suggested turnover by tank type
- Shrimp and fry: gentle, well under 4 times an hour, with a sponge on the intake.
- Low-tech planted: 4 to 5 times an hour, enough to carry nutrients without stirring the water.
- Planted with CO₂: 8 to 10 times an hour, often two filters or a filter and a wavemaker, so CO₂ and nutrients reach every corner.
- Community fish: about 6 times an hour; heavily stocked or messy fish: up to 10 times, with 6 as the floor.
These bands come from our filtration research notes, which draw on a filter flow guide and aquarium forum threads, and they agree with each other. They are habits among keepers rather than tested requirements, and the best number for your tank also depends on how the outlet spreads flow and on the animals' tolerance, so read them as a starting range.
Limits
Real flow also falls with head height, hose length and bends, outlets that restrict flow, and months of clogging, and each of these can cut it further. Sponge filters, hang-on-back filters and wavemakers are rated differently and a chart cannot capture all of them. This tool does not size UV sterilisers, test your filter, or cover biological capacity, which depends on media volume and stocking more than on flow.
Sources
Rated-versus-real ratios: the Eheim 2215 and 2217 bucket test thread on aquaticquotient.com (opened for this page), the Eheim 2213 flow thread on plantedtank.net and Fluval's published pump and circulation figures for the FX2, FX4, FX6, 307 and 405, as recorded in our equipment research notes (marked as estimates there). Dirty or densely packed share (35–50%): our working estimate, with no independent test behind it. Turnover bands: our filtration and flow research notes. Filter listings come from our equipment pages.
More calculators
Tank volume
Litres, gallons and weight for any tank shape, and the real water once soil and rocks are in.
Open →Tank mates
Can these fish, shrimp and snails live together? Shared water, tank size, groups and who eats whom.
Open →CO₂
CO₂ from pH and KH, drop checker colours, and how long your cylinder lasts.
Open →Soil and substrate
How many litres and bags of aqua soil your tank needs, with a deeper slope at the back.
Open →Heater and cooling
Heater watts for your room, and when a hot room needs a fan or chiller instead.
Open →Plant finder
Which aquarium plants will thrive, grow with a catch, or not work in your tank.
Open →Water change
How much to change to bring nitrate down, and the level after each change.
Open →Fertiliser dosing
Grams of dry salts or mL of a liquid per dose and per week, from weekly ppm targets.
Open →Light finder
Which lights reach your plants at your tank depth, from PPFD readings we hold.
Open →Shrimp water
Is new water safe for shrimp? TDS, GH, KH and temperature steps, and drip time.
Open →