Wiki

Free aquarium calculator

Aquarium fertiliser dosing calculator

Turn weekly nitrate, phosphate, potassium and iron targets into grams of dry salts or millilitres of a liquid fertiliser for your water volume, per dose and per week, with safe-start advice.

Your tank and targets

L
Use the water left after soil and rocks (the tank volume calculator gives it).
Weekly targets
ppm per week
ppm per week
ppm per week
ppm per week

ppm added over the week. The two buttons are the low and high end of the range our sources share.

Schedule

%
Used only for the build-up estimate. Set 0 if you do not change water weekly.
×
×
What are you dosing with?
%
Percent Fe on the label. The Plantex CSM+B label lists 7%; use your own product's figure.

Results

Start low and watch the tank
These are estimates from published hobby ranges, not a prescription. Begin at the lower button, test nitrate and phosphate with a kit, and watch fish, shrimp and plants for a week before raising anything. Never go above the dose on your product's label. Shrimp and other sensitive livestock may need lower doses or a different method. This tool gives plant fertiliser amounts only: it never gives medicine or treatment doses.
Potassium nitrate (KNO₃)0.33 g0.98 g per week
Monopotassium phosphate (KH₂PO₄)0.03 g0.09 g per week
Potassium sulphate (K₂SO₄)0.15 g0.44 g per week
Trace mix0.06 g0.17 g per week
Potassium already supplied by KNO₃ and KH₂PO₄
6.7 ppm
Build-up if plants used none: Nitrate (NO₃)
up to 20 ppm
Build-up if plants used none: Phosphate (PO₄)
up to 2 ppm
Build-up if plants used none: Potassium (K)
up to 20 ppm
Build-up if plants used none: Iron (Fe, from trace mix)
up to 0.4 ppm
Too small to weigh
A dose under 0.1 g is too small for a kitchen scale, which reads to about 1 g, and only roughly measurable on a common 0.01 g jewellery scale, where one step of the display is 10% of the dose. Dissolve a week's amount in a measured bottle of water and dose a set number of millilitres instead.

The link and the PDF keep your numbers, so you can come back or share them.

Before you dose

Fertiliser only works when light and CO₂ keep up.

How this calculator works

This calculator turns weekly nutrient targets into grams of dry salts or millilitres of a liquid fertiliser for your water volume. It follows the estimative index (EI) style of dosing for planted tanks: give the plants a steady surplus of nitrate, phosphate, potassium and trace elements, then reset with a large weekly water change.

How it works

  • Dry salts. Each salt is a known compound, so the share of a nutrient in a gram of it follows from atomic masses: KNO₃ is about 61.3% nitrate and 38.7% potassium, KH₂PO₄ is about 69.8% phosphate and 28.7% potassium, and K₂SO₄ is about 44.9% potassium. Grams = target ppm × litres ÷ the nutrient share ÷ 1000. KNO₃ and KH₂PO₄ also carry potassium, so that is counted first and only the shortfall is added as K₂SO₄.
  • Trace mix. You give the iron percentage from its label, and the grams are the iron target × litres ÷ that percentage ÷ 1000. A trace mix holds other elements too, in the proportions on its label.
  • Liquids. Type the mg of each nutrient per mL from the label. The calculator divides the weekly amount you need by that figure. One bottle seldom matches all four targets, so it shows the volume for each and the smallest dose as a safe limit.
  • Per dose. The weekly total is split over the number of macro and trace doses you choose. A common split is three macro days and three trace days, kept apart because iron and phosphate can precipitate together.

Where the target ranges come from

The window is nitrate 10 to 20 ppm, phosphate 1 to 2 ppm, potassium 10 to 20 ppm and iron 0.2 to 0.5 ppm per week. It is a cautious middle of published ranges, where two named sources overlap: Aquarium Science's weekly EI targets (nitrate 5 to 30, phosphate 1 to 2, potassium 10 to 30, iron 0.2 to 0.5 or more) and the levels Rex Grigg suggests keeping in the water (nitrate 10 to 20, phosphate 1 to 2, potassium 10 to 20, iron 0.1 to 1.0). Grigg gives levels rather than weekly totals, so the match is approximate. Published ranges differ: GWAPA gives iron about 0.1 ppm and phosphate 0.5 to 2, Aquarium Lesson puts EI nitrate at 20 to 30 ppm a week, and lean methods aim lower still. Treat the window as a sensible starting point, not a rule. The "Start low" button is its low end and "Standard" its top.

The build-up estimate

If a fraction f of the water is changed each week and the plants take up nothing, a nutrient settles at the weekly dose divided by f by the end of a week: twice the weekly dose at a 50% change. Real tanks use some, so this is a worst case. It is our own arithmetic, not a reading.

Safety

  • Start at the low button and test nitrate and phosphate with a liquid kit before raising anything.
  • Never exceed the dose on your product's label.
  • Shrimp and other sensitive animals can need lower doses or a different method; one EI guide calls full-strength EI unsuitable for sensitive shrimp tanks without changes. Check the trace mix label for copper.
  • Fertiliser without enough light and CO₂ feeds algae. Check those first.
  • This tool never gives medicine, salt or treatment doses.

Limits

Targets are estimates and tanks differ in stock, plants, light and tap water. Test kits for phosphate and nitrate are only roughly accurate, and trace mixes differ between brands. If your plants and fish look well, your own dose beats this page.

Sources

More calculators