Wiki
Water problems

Ammonia spike

Also calledammonia poisoninghigh ammoniaammonia burnmini-cycleaquasoil ammoniaamazonia ammonia

Ammonia, the toxic waste that fish and rotting food give off, builds up faster than the filter bacteria can break it down. It is an emergency: it burns the gills and can kill fish and shrimp within days.

How urgentAct now

Fish or shrimp can die within hours or days.

What you see

  • An ammonia test reads above zero
  • Red or purple gills and gasping at the surface
  • Clamped fins, sluggish fish and loss of appetite
  • Dark or red streaks on the body; in bad cases, curling or twitching

Could it be something else?

Why it happens

  1. Something dead or rottingA dead fish or snail, uneaten food or decaying plants turn straight into ammonia.
  2. Filter bacteria knocked backRinsing media in tap water, cleaning all of it at once, some medicines or a long power cut can kill the bacteria that remove ammonia.
  3. Too many fish or too much foodMore waste goes in than the filter can process.
  4. New or disturbed aquasoilRich aquasoil releases ammonia in its first weeks, and again after replanting or heavy digging.
Step by step

Fix it now

Safety first: if a step uses a medicine, treatment or salt, follow the product label and never go above the labelled dose. Check the label for animals it can harm, such as shrimp, snails and scaleless fish, and for whether to remove carbon. If you are unsure, or animals keep dying, ask an aquatic vet.

  1. Change 40–50% of the water with dechlorinated, temperature-matched water
  2. Add a conditioner that binds ammonia for a short time, following the label dose
  3. Remove anything dead or rotting and any uneaten food
  4. Feed very little until the tests are clear
  5. Retest and repeat the water change every 12–24 hours until ammonia reads zero
  6. Find the cause: a dead animal, overfeeding, or a filter that was cleaned or stopped

Stop it coming back

  • Test ammonia for several days after cleaning the filter, medicating, a power cut or adding fish
  • Feed only what the fish eat in 1–2 minutes
  • Clean filter media in removed tank water, and never all of it at once
  • Add new fish a few at a time

Common questions

Why does my new aquasoil give an ammonia reading?
Some active soils, aquasoil among them, release ammonia when they are new and wet. This is separate from a dead fish or overfeeding, and it is usually strongest in the first weeks. Test before you add any fish.
When can I add fish to a tank with new aquasoil?
Wait until ammonia and nitrite both read zero on repeated tests, however long that takes. Planting heavily and starting the filter with media from a mature tank helps the filter bacteria catch up. Never add fish to a reading above zero.
Does a low pH from aquasoil make the ammonia safe?
Not safe, only less toxic. The same total ammonia reading contains more of the poisonous free form as pH rises, so a lower pH gives some protection but the reading still has to reach zero. Treat any ammonia above zero as a reason to act.
Why did my KH and pH drop after I set up aquasoil?
Aquasoil is sold to soften water and lower pH, and the filter bacteria also use up KH, the carbonate buffer, as they turn ammonia into nitrate. In soft tap water there is little KH to start with, so it can run out, and once the buffer is gone pH can fall quickly. Test KH, then raise it slowly with a KH or remineralising product, following the label, and read the pH crash and swings guide.
How do I deal with ammonia from new soil with fish already in the tank?
Follow the steps above: regular water changes with dechlorinated, temperature-matched water, an ammonia-binding conditioner as a short-term help only (follow the label), and very light feeding. If readings stay above zero, move the animals to a separate tank with established filtration.
Is ammonium (NH4) toxic? My kit says it is high.
Ammonium is much less toxic than ammonia gas. UF/IFAS says un-ionised ammonia (NH3) is about 100 times more toxic to fish than ammonium (NH4+), because it passes through gill membranes more easily. But the two are the same thing in different forms, and most kits report them added together as total ammonia. Any reading above zero needs action, because the share that is NH3 can rise.
What do ammonia test kits actually measure?
UF/IFAS says most commercial kits measure total ammonia nitrogen, which is NH3 and NH4+ together. A kit does not tell you how much of it is the toxic form. To find that you need the total reading, the pH and the temperature.
Does pH change how dangerous ammonia is?
Yes. The US EPA and UF/IFAS both say higher pH and higher temperature shift more of the total toward toxic NH3. Using the UF/IFAS table, 1.0 mg/L of total ammonia at pH 8.0 and 24 °C is about 0.05 mg/L of NH3, and UF/IFAS says damage to fish tissue can occur above 0.05 mg/L NH3. The same reading in lower-pH water holds less NH3.
My ammonia and pH both rose. Can I lower the pH to make it safe?
A lower pH makes a given reading less toxic, but it does not remove the ammonia, so the reading still has to reach zero. We found no reliable source for a safe way to push pH down quickly. UF/IFAS says a water change may help in small systems, so do partial changes with treated water, and test again.
Why does my kit still show ammonia after a water change or conditioner?
Two things can cause it. Ammonia may really be left, or it may be coming from the tap if your supplier uses chloramine, because ammonia is released as chloramine is removed (City of Hagerstown). Also, UF/IFAS says Nessler-type kits can read falsely high with ammonia-binding products and many water conditioners, while salicylate-type kits are not affected by them. Check which type you have.
Scape Eden community

Still stuck?

Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.

Sources

  1. Aquarium Science: Ammonia in Depth
  2. FAO: Chemical Features of Water
  3. US EPA: Ammonia (CADDIS)

How we made this

Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages

Cite this page

Copy a ready-made line to credit this page in your own writing.

Citation

Scape Eden. “Ammonia poisoning in fish: symptoms and fixes”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/ammonia-spike

Reference style (APA)

Scape Eden. (2026, October 15). Ammonia poisoning in fish: symptoms and fixes. Scape Eden. https://scapeeden.com/wiki/problems/ammonia-spike

Plain link

https://scapeeden.com/wiki/problems/ammonia-spike

Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.