Wiki

Free aquarium calculator

Aquarium water change calculator

How much water to change to bring nitrate, or any dissolved substance, down to a level you choose, and where the level sits after each change.

Your tank and water

L
Litres of actual water, not the tank's label size. Don't know it? Work it out with the tank volume calculator
How much will you change?
%
From your test kit, for nitrate usually mg/L. Any substance works if all three levels use the same unit.
Your tap, or your mixed RO water, tested for the same thing. Use 0 for pure RO water.
The number you would like to see on the test kit.

Results

Water to change18 L30% of the tank
Level after one change29.5down from 40
Changes to reach 203 changes
A plan that gets there
Changing 18 L (30%) 3 times, leaving some days between them, takes the level from 40 to about 17, as long as nothing is added in between.
To get there in a single change
Change 57% of the tank, which is 34.3 L, and the level lands on 20. A big change in one go is harder on animals than several small ones, so use it as a ceiling, not a target.

The link and the PDF keep your numbers, so you can come back or share them.

Level after each change

After change 1
29.5
After change 2
22.2
After change 3
17
After change 4
13.4
After change 5
10.9
After change 6
9.1

Next steps

Once you know how much to change, check what to put in the tank and how to size the gear.

How this calculator works

This calculator answers two questions: how much water to change to bring a dissolved substance such as nitrate down to a level you choose, and how that level moves over several changes. You give the real water volume, the level in the tank now, the level in the water you are adding, and the level you want. You can describe the change as a percentage or as an amount in litres or gallons, and the other is worked out for you.

The sum behind it

A water change is a dilution. If you replace a share f of the tank, you keep a share (1 − f) of the old water and add f of new water. The new level is the new-water level plus the difference between the old level and the new-water level, multiplied by (1 − f). Written out: new level = tap + (now − tap) × (1 − f). Repeat it n times and the factor becomes (1 − f) to the power n, which is why the first change removes the most and each later one removes a smaller amount. To find the number of changes the calculator solves that for n and rounds up, and for the single change that hits the target exactly it uses (now − goal) ÷ (now − tap).

What it assumes

  • The new water mixes fully and fast with the tank. In real tanks, plant roots, deep soil and dead corners hold water back, so the result is a little optimistic.
  • Nothing adds the substance between changes. Feeding, fish waste and decaying matter keep producing nitrate, so the level rebounds. The plan shows the effect of the changes alone.
  • Soil, rocks and plants do not release or absorb the substance during the change. Nitrate is mostly untouched by them; substances such as phosphate, hardness and tannins can be.
  • Only the level in the new water matters. A target at or below it can never be reached by changing water, and the calculator says so.

Using it well

Test the tap water for the same thing you test the tank for, because tap water that already carries 10 or 20 mg/L of nitrate puts a floor under every result. Use the percentage mode for routine weekly changes and the amount mode when you know the size of your bucket. If a plan needs many changes, the cheaper fix is usually the source of the substance rather than more water.

Limits

This is a planning estimate for any substance that dilutes evenly, and it covers no medicine, salt or chemical doses. A test kit reading has its own error, often 10% or more, so treat a result of 19 mg/L against a target of 20 as on target. Changes of more than half the tank at once also change temperature and water chemistry quickly, which the sums cannot show.

Sources

The dilution formula is the standard well-mixed mass balance taught in introductory chemistry and used in water treatment; it has no constants, so no maker data or species ranges are involved. For why nitrate climbs and what to do besides changing water, read our problem guide: High nitrate.

More calculators