Wiki

Aquarium lighting schedule: how many hours of light a planted tank needs

Most planted tanks do well on 6 to 8 hours of light a day, on a timer. Low-tech tanks suit the short end, CO₂ tanks can run longer, and new tanks start at about 6 hours. Guides say brightness matters more than hours, and the siesta lacks strong evidence.

Updated · Scape Eden

The short answer

For most planted tanks, 6 to 8 hours of light a day, on a timer and at the same hours every day, is the right place to start. Low-tech tanks sit at the shorter end. Tanks with injected CO₂ and fertiliser can run longer, from about 7 hours up to 10 depending on which source you follow. A new tank starts shorter again.

  • Established low-tech tank (no CO₂): 6 to 8 hours at modest brightness.
  • Tank with CO₂ and fertiliser: 7 to 8 hours to begin with, and up to 10 once the plants are dense and nothing is growing algae.
  • New tank, first 2 to 3 weeks: about 6 hours (some guides say 5 to 6), then increase slowly.
  • Always: a timer, and a proper night. Do not leave the main light on overnight; guides disagree on whether a very dim moonlight is acceptable, so the safe choice is full dark.

Low-tech or CO₂: why the hours differ

Light, carbon and nutrients work together. In a tank with no added CO₂ the plants are limited by carbon, not by light, so extra hours go to algae rather than growth. That is why low-tech guides settle on 6 to 8 hours, and some say 6 to 7. Our planted tank without CO₂ guide explains the balance in full. Pick easy plants that suit the short day.

With CO₂ injection and fertiliser, plants can use more light and a longer day. Sources give different ceilings: one puts the standard at 7 to 8 hours, while two others list 8 to 10 hours for high-tech tanks. Check your dissolved gas with the CO₂ calculator and your feeding with the fertiliser calculator before you add hours.

Match the gas to the light. Sources differ on timing: one starts CO₂ 1 to 2 hours before the lights and stops it an hour before lights-out, while another starts 2 to 3 hours before and stops it with the lights. A power cut can leave the light and CO₂ timers out of step, and the swings can start black beard algae; see power cuts.

Intensity matters more than hours

Two knobs control how much light a tank gets: how bright the light is and how long it stays on. Two of the guides we read say brightness has the bigger effect on plants and algae, though neither is a controlled trial. In low-tech tanks, turning the light down is often a better fix than shortening the day, because it lowers the energy pressure on the whole system.

So a tank on a 6-hour day can still grow algae if the light is too strong for its plants. When choosing a fitting, compare PPFD at your tank depth, not watts or lumens. The light finder does this for the lights where we hold a published or measured PPFD curve, and lists lights with no reading separately instead of guessing. See also the lighting equipment pages.

Dimming is the easiest way to experiment. Aquarium Co-Op suggests starting its own planted-tank light at roughly 20 to 40% brightness and raising it only if no algae appears; brightness percentages differ between fittings, so treat this as a rough starting point. If algae shows, step the brightness back down.

A starting schedule for a new tank

A new tank has few plants, so keep the light short at first. Tropica advises 6 hours a day for the first 2 to 3 weeks, then 8 to 10 hours, while a retailer guide starts at 5 to 6 hours and builds up over 6 to 8 weeks.

  1. Weeks 1 to 3: about 6 hours on a timer, with plenty of plants, including fast stems or floaters that use nutrients quickly.
  2. Weeks 3 to 8: if there is no new algae, add a little time. Make one change at a time and give it time before changing anything else; Aquarium Co-Op suggests about two weeks for low-tech tanks, and some keepers wait longer.
  3. Established: settle at the hours that keep the plants growing and the glass clean, usually inside the ranges above.

Expect some algae anyway. Soft brown dust in the first weeks is normal; see brown algae (diatoms), and follow the start-up steps in how to cycle a new tank and aquascaping for beginners.

Timers, ramping and a real night

Use a timer. A plug-in timer is more reliable than remembering, and the same hours every day matter more than the exact number.

  • Ramp up and down. A light that jumps from dark to full brightness can stress fish, and a sunrise and sunset ramp is gentler. One retailer guide counts only time above roughly 30% brightness towards your hours, so treat a long ramp as part of the day; we found no second source for that figure.
  • Keep a real night. Plants respire in the dark, and Aquarium Co-Op warns that algae can exploit continuous light. Two retailer guides give 8 to 12 hours of darkness a day as a target; we found no independent measurement.
  • Skip the all-night blue light too: Aquarium Co-Op says not even a moonlight mode should stay on, while another guide allows a moonlight below about 5% of full output. Neither is tested, so full dark is the safer choice.

The siesta: a split photoperiod, and what the evidence says

A siesta splits the day into two lit blocks with a dark break in the middle. The common patterns are 4 hours on, 2 off, 4 on, and 5 to 6 on, 2 to 3 off, 5 to 6 on. The idea behind it is that plants can start and stop photosynthesis quickly, while some algae need a long, unbroken stretch of light to settle. That is a theory, not a measured result.

The evidence is thin. One guide says results are mixed: some keepers report less algae and others see no difference, and scientific evidence is limited. In one forum discussion, keepers who tried a split day saw no major change in algae or growth. We found no controlled trial. Treat it as something that may help, not a proven fix.

If you try it, change nothing else for a few weeks and compare. Check the basics first: a siesta does not replace the right light for your depth, steady CO₂ or enough nutrients.

Depth: how much light reaches the plants

Light fades in water. In Tropica's example, raising a plant 10 cm towards the lamp gave it about 40% more light in the middle of the tank, though much less in the corners; the exact figure depends on the fitting and its height. Aquarium Co-Op's PAR guide makes the same point in general terms: deeper tanks receive less light, and glass lids, tannins and surface ripple take more away. We found no published figure for how much is lost at a given depth, so measure with a PAR meter or compare lights at your own depth.

Adding hours does not rescue a carpet on the floor of a deep tank; stronger light or shallower plants do. If the lowest plants fade, read too little light. If tall stems shade the ones below, see plants shading plants and leggy stem plants.

How much light do plants need, in numbers? The PPFD bands are contested. Aquarium Co-Op puts low light at 10 to 20, medium at 20 to 35 and high at 40 to 50 and up (µmol/m²/s at the plants). Aquarium Lesson suggests 20 to 40 for a balanced tank without CO₂, with 10 to 20 for shade plants and 40 to 60 as the upper edge before algae risk rises. Our light finder uses its own working estimates of 20 to 30 for low, 30 to 50 for medium and 50 to 80 for high, which sit between published bands that differ. Treat all of them as a guide.

Daylight in the room

Sunlight through a window adds light you cannot time or measure. Direct sun is the thing to avoid, and bright light is a common trigger for green water. Move the tank out of direct sun or block it. Floating plants such as Amazon frogbit shade a tank and take up nutrients.

Fish and shrimp

A fixed day and night suits fish and shrimp as well as plants, and a sudden switch-on can stress fish, so a ramp is gentler. We found no shrimp-specific lighting figures, so follow the schedules here. Floating plants and dense planting give shade to retreat to in a bright tank. Check stocking with the tank mates calculator.

Light and algae: what to change first

Too much light can feed algae in low-tech tanks, but it is rarely the only cause.

  • Hair algae: too much light can contribute, but low nutrients, low CO₂ and weak flow are also linked. Keep the day inside the ranges above and keep CO₂ steady.
  • Green spot algae: strong light on slow leaves plays a part, but low phosphate is the usual cause, so check phosphate before the schedule.
  • Green water: look at direct sun and overfeeding before the schedule.
  • Black beard algae: often linked to unstable CO₂ and low flow, so fix CO₂ swings and timer mismatches, not just the hours.
  • Brown algae (diatoms): normal in the first weeks of a new tank; usually fades as it settles.
  • Blue-green algae: look at stagnant water and flow dead spots; light is not the usual cause.
  • Pearling but dying: the bubbles show the plants were photosynthesising that afternoon, not that nutrients are right.

When plants are slow even under decent light, the cause is often carbon or nutrients; see slow growth. Change one thing at a time, give it a couple of weeks, and keep notes.

Keep reading

Sources

We read these pages and wrote the guide in our own words. Species, problem and tool details come from our own wiki pages linked above.

How we made this

Written with AI assistance from the sources listed here and checked against them. Not yet reviewed by an expert. Report a mistake · How we write and check pages