Wiki

Free aquarium calculator

Shrimp water change and acclimation checker

Check a water change or a new bag of shrimp against your tank before it goes in: how far TDS, GH, KH and temperature will jump, the biggest change that stays gentle, and how long to drip new shrimp.

Your shrimp and water

Shrimp type
What are you checking?
L
Litres of actual water, not the tank's label size. Don't know it? Work it out with the tank volume calculator
%

Tank water now

°C

New water

Test the new water after any conditioner, remineraliser or RO mixing, at the temperature you will pour it.
°C

Results

TDS jump24 ppmtank goes 200 → 224
GH jump0.8 °dHtank goes 7 → 7.8
KH jump0.6 °dHno published limit, watch it
Temperature gap0 °Cnew water against tank
Biggest gentle change17%10 L in one go
Borderline: split it or match the water
At least one reading moves more than the cautious limit. Change 17% or less at a time, a few days apart, or bring the new water closer to the tank first.
Rules of thumb, not lab limits
These limits come from shrimp breeders' guides, mostly one source each, not from controlled studies. Treat "gentle" as low risk, not a promise.

The link and the PDF keep your numbers, so you can come back or share them.

Next steps

Get the water right, then check who shares the tank with your shrimp.

How this calculator works

Dwarf shrimp handle a wide range of water when they grow up in it, but they react badly to sudden change. This checker compares the water you are about to add, or the water new shrimp arrive in, with your tank, and tells you how big each jump is.

How the jump is worked out

For a water change, TDS, GH and KH after the change are a plain dilution: tank + (new − tank) × share changed. The jump is the difference between that and the tank now. Temperature is judged on the raw gap between the new water and the tank, because the shrimp swim into the new water before it mixes. The biggest gentle change is the share that keeps both the TDS and GH jumps inside the gentle limit.

The limits we use

ReadingCherry-typeBee and tiger
TDS jump per change (gentle / borderline)20 / 30 ppm†10 / 20 ppm†
GH jump per change1 / 2 °dH†1 / 2 °dH†
Temperature gap1 / 3 °C†1 / 3 °C†
Minimum drip for new shrimp45 min†90 min†

Why these numbers

  • TDS: one breeder guide asks for new water within 10–20 ppm of the tank for cherry shrimp and 5–10 ppm for bee shrimp; another says not to raise TDS by more than 20–30 ppm a day. We take the upper end of the first range as gentle and the 20–30 ppm figure as the outer borderline limit, and apply it to drops as well as rises (for lowering TDS that guide only says to replace no more than 20–25% at once).
  • GH and temperature: the same breeder guide asks for within 1 °dH and within 1 °C. The borderline bands above that are our own margin.
  • Shrimp guides give 1–3 hours of drip acclimation at 1–2 drops a second, dripping until the water is at least tripled; one goes further, until about three quarters of the water is new. One guide allows 2–3 drops a second for cherry shrimp; we keep the slower 1–2 for both. No source gives times by TDS gap, so the longer bands are our estimate.
  • KH and pH: we found no published per-change limit, so the checker shows the KH jump without a verdict.

Limits

All limits are hobby rules of thumb from shrimp breeders and shops, not results from controlled studies, and most rest on a single source. Shrimp raised in hard water live well in it; the danger is the jump, not the number. Chlorine, chloramine, copper and ammonia in the bag can kill shrimp even when every reading matches, so always use a conditioner and never pour shop water into the tank.

Sources

Gensou (water changes and drip acclimation), ShrimpKeepers (TDS), aquariumbreeder.com (TDS, drip acclimation), Shrimp Science (drip acclimation), Shrimp Up Aquatics (acclimation guide), checked October 2026. See also which fish eat shrimp.

More calculators