Wiki
Water problems

Too much CO₂

Also calledCO₂ overdosegassed fishCO₂ poisoningCO₂ gassingis my CO2 workinghow do I know my CO2 is working

Injected CO₂ has built up so high that fish cannot breathe properly. It is one of the biggest causes of fish deaths in planted tanks, most often in the dark hours, so turn the CO₂ off first and ask questions later.

How urgentAct now

Fish or shrimp can die within hours or days.

What you see

  • Fish gasp at the surface, most often during CO₂ hours or in the early morning
  • Fast, laboured gill movement and erratic or 'drunk' swimming
  • Fish lying on the bottom or bunched near the surface in a corner
  • Shrimp look drunk or stop moving

Could it be something else?

Why it happens

  1. CO₂ running at nightRunning CO₂ all day and night adds gas on top of what plants and fish breathe out in the dark. It is a leading cause of overnight fish loss.
  2. Bubble rate raised too fastBig jumps in bubble rate overshoot before a drop checker can show it; drop checkers lag the tank by several hours.
  3. Surface ripple stoppedA blocked filter, a power cut or a lowered outflow stops the CO₂ from gassing off.
  4. Needle valve creep or a faulty regulatorCheap regulators can slowly let more gas through, or dump the last of a cylinder at once.
Step by step

Fix it now

  1. Turn the CO₂ off now at the solenoid or needle valve
  2. Make as much surface ripple as you can: air stone, filter outflow at the surface or a powerhead
  3. Change 20–30% of the water with dechlorinated water, and repeat once if fish are still struggling
  4. Turn the flow back down once fish recover, so tired fish are not pushed around by strong current
  5. Restart CO₂ later at a lower rate and watch the fish

Stop it coming back

  • Put CO₂ on a solenoid and timer: on 1–2 hours before lights-on, off about an hour before lights-off
  • Raise the bubble rate in small steps every 2–3 days, watching the fish
  • Run an air stone or stronger surface ripple after lights-out
  • Use a proper solenoid so a power cut shuts the gas off

Common questions

Is my CO₂ working? What should my drop checker look like?
A drop checker holds a small amount of reference solution (4 dKH) with a colour indicator, separated from the tank water by an air gap so only CO₂ changes its colour. With that reference, lime green means roughly 25 to 35 ppm; bluer means less and more yellow means more. It reacts slowly and works like an average of the last few hours, so read it after a steady stretch, not minutes after a change.
How can I reach 30 ppm of CO₂?
Raise the bubble rate a little at a time and let the drop checker catch up before the next step. Start the CO₂ about an hour before the lights go on. Remember that 30 ppm is not a target you must hit: Aquarium Science suggests 16 to 24 ppm for a moderately stocked tank, and fish safety comes before plant speed.
Why is my CO₂ not dissolving or why do I seem to lose it?
Common causes are a clogged diffuser, a leak at a tube or joint, or a blocked or kinked line. Clean the diffuser as its maker describes, check the joints and line, and compare the bubble rate with the drop checker. Aquarium Science says a reactor uses CO₂ 50 to 100% more efficiently than a bubble diffuser.
How long does CO₂ take to build up and to off-gas?
There is no fixed time: it depends on your bubble rate, aeration and tank. Aquarium Science gives one worked example for a 50-gallon (about 190 litre) tank: about two hours to reach 30 ppm at three bubbles a second with moderate aeration, and about six hours at one bubble a second with none. To bring the level down, turn the CO₂ off and increase surface movement; if fish are gasping, do that at once and do not wait for the drop checker.
Scape Eden community

Still stuck?

Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.

Sources

  1. 2Hr Aquarist: Gasping fish does not automatically mean good CO2 levels
  2. UK Aquatic Plant Society: Am I gassing my fish with CO2?
  3. CO2Art: Signs of too much CO2
  4. Practical Fishkeeping: CO2, striking the balance
  5. Aquarium Science: Measuring CO2

How we made this

Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages

Cite this page

Copy a ready-made line to credit this page in your own writing.

Citation

Scape Eden. “Too much CO2 in the aquarium: signs and fixes”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/too-much-co2

Reference style (APA)

Scape Eden. (2026, October 15). Too much CO2 in the aquarium: signs and fixes. Scape Eden. https://scapeeden.com/wiki/problems/too-much-co2

Plain link

https://scapeeden.com/wiki/problems/too-much-co2

Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.