Wiki
Water problems

Soft or RO water: remineralising

Also calledremineralize RO waterRODI planted tankgh boosterraise gh aquariumro water gh khzero magnesium

RO and RO/DI water have had almost all their dissolved minerals removed, so GH (calcium and magnesium) and KH (the pH buffer) read very low. It is not an emergency on its own, but pH can swing, and plants, shrimp and snails can struggle, until you add minerals back in a controlled way.

How urgentNot urgent

Mostly a looks problem. Fix it steadily.

What you see

  • GH and KH tests that read zero or very close to it
  • pH that moves a lot, especially after water changes or with CO₂
  • New plant leaves that are curled, pale or distorted although you dose fertiliser
  • Shrimp that fail to moult after a change in hardness, or snails with thin, pitted shells

Could it be something else?

  • pH crash and swings: That is the KH side of the same problem: too little buffer, often after RO water
  • Hard water (high GH): That is the opposite problem, too many minerals
  • Pale new leaves: Pale new leaves have other causes too, such as an iron shortage

Why it happens

  1. Pure RO or RO/DI water used as it isThese filters strip out almost all minerals, so the water has no GH from calcium and magnesium and little KH to hold pH steady.
  2. A remineraliser that only raises GHA GH booster adds calcium and magnesium (for example Equilibrium, which the maker says does not raise KH and needs a separate buffer for that). The tank stays low in KH until a buffer is added.
  3. Wrong or inconsistent mixingA powder that is not fully dissolved, or a different amount each week, gives a different GH each time, so plants and livestock never settle.
Step by step

Fix it now

Safety first: if a step uses a medicine, treatment or salt, follow the product label and never go above the labelled dose. Check the label for animals it can harm, such as shrimp, snails and scaleless fish, and for whether to remove carbon. If you are unsure, or animals keep dying, ask an aquatic vet.

  1. Test GH and KH on the finished water you put in the tank, not only the RO output. A TDS pen shows total dissolved solids but cannot tell you whether they are calcium and magnesium
  2. Stop adding pure RO or RO/DI water to the tank; remineralise or blend it first
  3. Use a remineraliser made for aquariums that suits your livestock, and check its label for shrimp and snails
  4. Dissolve the powder in a jug of water first, as the maker advises, then add that to the new water, and follow the label dose. Equilibrium's dose assumes RO or RO/DI water; for any other water, measure GH first
  5. Add a separate KH buffer if your plants or CO₂ set-up need KH, in small steps, testing between them
  6. Test the mixed water, then change the tank water in small, regular amounts until GH and KH settle where you want them
  7. Another option is to blend RO with a known share of tap water instead of remineralising pure RO; test the blend every time

Stop it coming back

  • Mix new water the same way every time, and test it before it goes in
  • Remineralise new water, not the tank; do not use a GH booster to top up evaporated water (the maker says so, and evaporation leaves the minerals behind)
  • Keep a record of your numbers so a drift in GH or KH shows early
  • Make water changes small and regular instead of large and occasional

Common questions

How do I remineralise RO water?
Add a remineraliser made for aquariums to the new water before it goes in, following the label dose. Dissolve the powder in a jug of water first, then test GH and KH on the mix. Add a separate KH buffer if you need KH.
Which GH booster should I use, liquid or powder?
We could not source a difference between forms. What matters is that it adds calcium and magnesium, that you follow the label dose and that you mix it the same way each time. The maker of Equilibrium (a powder) says to dissolve it in water first; it may leave a slight haze that clears.
Why are my plants struggling in remineralised water?
GH or KH that is still too low, or numbers that change from one water change to the next, are possible reasons. Test the mixed water, correct one thing at a time and keep the recipe steady. If new leaves are twisted or pale, see the twisted new growth and pale new leaves guides, which have other causes.
Does my RO water have zero magnesium?
RO and RO/DI water has had almost all its minerals removed, so assume it has almost none until you add them. A GH booster that lists calcium and magnesium, as Equilibrium does, puts both back.
Scape Eden community

Still stuck?

Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.

Sources

  1. Seachem Equilibrium (GH supplement for RO/DI water; does not raise KH; dissolve first; not for evaporated water)
  2. Seachem Alkaline Buffer (sodium bicarbonate based KH buffer)
  3. SRAC 4606: Interpretation of Water Analysis Reports for Fish Culture (hardness is mostly calcium and magnesium; alkalinity buffers pH)
  4. Seriously Fish: Parosphromenus nagyi (RO unit for soft water; small, regular weekly water changes)
  5. Seriously Fish: Betta foerschi (RO unit for soft water; small, regular water changes)

How we made this

Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages

Cite this page

Copy a ready-made line to credit this page in your own writing.

Citation

Scape Eden. “Soft or RO water: how to remineralise it”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/soft-ro-water-remineralise

Reference style (APA)

Scape Eden. (2026, October 15). Soft or RO water: how to remineralise it. Scape Eden. https://scapeeden.com/wiki/problems/soft-ro-water-remineralise

Plain link

https://scapeeden.com/wiki/problems/soft-ro-water-remineralise

Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.