Wiki
Layout and setup

Changing substrate in an established tank

Also calledswap substrate planted tankadd aquasoil to existing tankgravel to soiladding sand to established tankreplace substrate established tankactive substrate established tank

Swapping, adding or digging out substrate in a running tank stirs up waste, can release harmful gas, and can add fresh soil that leaks ammonia. It is not an emergency, but done in one go it can crash a stable tank.

How urgentNot urgent

Mostly a looks problem. Fix it steadily.

What you see

  • You want to change gravel for soil, add a sand layer or replace old soil in a tank with livestock
  • Ammonia or nitrite reads above zero in the days after the change
  • Cloudy water, or a rotten egg smell when the substrate is dug up
  • Fish hiding, gasping or losing colour after the substrate was disturbed

Could it be something else?

  • Plant soil worn out: The soil is simply old and out of nutrients; adding root tabs may be enough, with no need to replace it
  • Rotten egg smell: The smell is already there and you did not change the substrate; this guide is about doing the swap safely

Why it happens

  1. Fresh soil leaks ammoniaSome active soils release ammonia when new and wet. A mature filter helps, but it may not keep up with a sudden extra load of ammonia.
  2. Gas pockets and waste dug upPacked substrate with little oxygen can turn sour as waste rots. Digging into it can release foul gases, including hydrogen sulphide, which smells of rotten eggs and is toxic.
  3. Bacteria and plant roots disturbedDigging out old substrate removes some of the waste-eating bacteria that live on it, and torn-up plant roots rot and add ammonia. A large change can slow the tank's waste processing for a while.
  4. Sudden water chemistry shiftActive soil can lower pH and KH, while sand or gravel made of shell or limestone can raise them. Fish, shrimp and plants dislike a fast change.
Step by step

Fix it now

  1. Unplug the heater and filter before reaching into the tank, and keep mains sockets and cables away from water
  2. Test ammonia, nitrite, pH and KH before you start, so you know what is normal for the tank
  3. Change a little at a time where you can: add a new layer in one section, then wait and test before doing the next
  4. For a full swap, move the animals to a spare tub with some of the tank's water, and keep the filter media wet in tank water without scrubbing it, because hard cleaning strips off the bacteria
  5. Dig out old substrate slowly and rinse it away from the tank; if you smell rotten eggs, stop, ventilate the room and keep your face away from the hole
  6. Prepare new substrate as its maker says, then put the filter back on and test ammonia and nitrite every day until they are steady at zero
  7. If ammonia reads above zero, change water with dechlorinated, temperature-matched water, feed very little and use the ammonia spike guide; do not return animals until it reads zero

Stop it coming back

  • Choose the substrate before you stock the tank, as changing it later is harder than getting it right the first time
  • Do not vacuum or dig deep into the substrate during routine care
  • Plan upgrades from gravel to soil as a partial change or a capped layer rather than a total tear-down
  • Keep a spare tub, a bucket of tank water and a ready air pump on hand before starting

Common questions

Can I add aquasoil to an established tank?
Yes, but expect it to release ammonia like any fresh soil, even if the filter is mature. Add it in stages or with the animals moved out, and test ammonia daily. Check the pH and KH too, because aquasoil can lower both.
Can I change gravel to sand without cycling again?
If the filter media stays wet and running, much of the tank's bacteria stays with the filter. Inert sand does not leak ammonia, but digging out the old gravel can stir up waste. Remove the animals if you are doing the whole tank, and test ammonia after.
Will swapping substrate crash my tank?
It can if you do everything at once, since fresh soil adds ammonia and digging disturbs waste. A staged change with testing is much safer than one big swap.
Should I take the fish out when changing substrate?
For a full swap or adding rich soil, yes if you can. Put them in a covered tub with some of their own tank water, aeration and a heater if needed, and return them only when ammonia and nitrite read zero.
Scape Eden community

Still stuck?

Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.

Sources

  1. Aquarium Science: Ammonia in Depth
  2. Aquarium Science: Walstad aquarium
  3. Aquarium Science: Tap water rinsing
  4. ATSDR: Hydrogen sulfide ToxFAQs

How we made this

Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages

Cite this page

Copy a ready-made line to credit this page in your own writing.

Citation

Scape Eden. “Changing substrate in a running tank safely”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/changing-substrate

Reference style (APA)

Scape Eden. (2026, October 15). Changing substrate in a running tank safely. Scape Eden. https://scapeeden.com/wiki/problems/changing-substrate

Plain link

https://scapeeden.com/wiki/problems/changing-substrate

Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.