Sterilising a tank, rocks or filter after disease
Bleach can disinfect an empty tank and hard equipment after disease, but it also kills the filter bacteria, and we found no authoritative test of how well it rinses out of porous rock or sponge. Whether a full strip-down is needed depends on the illness, so find that out first.
Mostly a looks problem. Fix it steadily.
What you see
- Fish died or were sick and you want to start again with new fish
- Green algae coating porous rock that will not scrub off
- A second batch of fish falling ill in the same tank after a restart
- An illness such as fish TB, which experts say is hard to remove
- A filter or equipment you cannot clean easily
Could it be something else?
- New tank syndrome: After you sterilise, the tank has no filter bacteria, so it must be cycled again like a new one
- Fish TB: The one disease where a full disinfection is widely advised
- Is this rock or object safe?: That guide covers checking new rock, not cleaning old rock
Why it happens
- Dirt and biofilm shield germsThe Merck Veterinary Manual says organic debris and biofilm protect germs from disinfectants, so surfaces must be cleaned before they are disinfected.
- Some germs resist bleachMycobacteria, which cause fish TB, have a thick fatty cell wall and can survive disinfectants and persist in biofilms and filter surfaces. Researchers who cleaned a zebrafish facility after an outbreak found complete removal very hard and said outbreaks can return in replacement fish. Merck says bleach alone does not work on them and that hard-to-reach surfaces may only see a big reduction.
- Hard-to-reach itemsMaine Sea Grant says rope is hard to disinfect and should be replaced. Porous rock and filter sponge are hard to reach in the same way, but we found no source that tests them.
- Bleach left behindThe zebrafish facility rinsed, air-dried and then tested for leftover chlorine daily for a week before restocking, so the rinse and a chlorine test matter as much as the soak.
Fix it now
Safety first: if a step uses a medicine, treatment or salt, follow the product label and never go above the labelled dose. Check the label for animals it can harm, such as shrimp, snails and scaleless fish, and for whether to remove carbon. If you are unsure, or animals keep dying, ask an aquatic vet.
- Find out what the illness was first, with an aquatic vet if you can, because the right method depends on the germ; we found no authoritative source saying when a full strip-down is needed
- Wear gloves, eye protection and a mask, ventilate the room, never mix bleach with other cleaners, and keep it away from other tanks with fish in the same room
- Remove the animals and scrub off dirt and biofilm first; disinfectants work badly on dirty surfaces
- Soak the empty tank and hard equipment in household bleach at about 200 to 250 mg/L (ppm) of chlorine; Merck says at least 1 hour, other sources use 30 minutes to 2 hours, and bleach strength varies, so work the amount out from your bottle's label
- Rinse very well with fresh water and let everything air-dry fully; before animals go back, check the final fill water with a chlorine test kit (see the chlorine guide) and wait until it reads clear
- Throw out cheap filter media, sponge and consumables rather than trying to disinfect them
- Cycle the tank again before new fish go in, because bleach also kills the filter bacteria; feed lightly and test ammonia, nitrite and nitrate as it settles
Stop it coming back
- Quarantine new fish in a separate tank so a problem never reaches the display
- Keep nets and tools for each tank separate
- Do not move equipment between tanks without cleaning it
Common questions
- Can I use bleach on porous rocks?
- Bleach works on hard, clean surfaces, but we found no authoritative test for porous rock, so we cannot say how well it rinses out. If you do use it, rinse and dry the rock thoroughly and check the water for chlorine before it goes back, or replace the rock.
- Do I need to sterilise my tank after fish died?
- Not always. We found no authoritative source that says every death needs a full strip-down; it depends on the cause. Merck advises disinfecting a tank that held fish with mycobacteria (fish TB) before other fish go in.
- Do I need new filter media after disease?
- Researchers who cleaned a zebrafish facility after a mycobacteria outbreak removed the filter media and autoclaved it before disposal. For a simpler illness we found no authoritative advice, so ask an aquatic vet.
- Will I need to cycle the tank again?
- Yes, if you disinfect the filter and media. Bleach kills the beneficial bacteria, so restart the tank as new, feed lightly and test the water while the filter settles.
Still stuck?
Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.
Sources
- Merck Veterinary Manual: Production medicine and biosecurity in aquaculture
- Maine Sea Grant and UMaine Extension: Disinfection for used shellfish equipment
- Racz, Dwyer and Killen: Eradication of Mycobacterium from a zebrafish facility (Zebrafish journal)
- Merck Veterinary Manual: Bacterial diseases of fish
- CDC: How to safely clean and sanitize with bleach
How we made this
Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages
Cite this page
Copy a ready-made line to credit this page in your own writing.
Citation
Scape Eden. “Sterilise a tank after disease: bleach and rocks”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/sterilising-a-tank-after-disease
Reference style (APA)
Scape Eden. (2026, October 15). Sterilise a tank after disease: bleach and rocks. Scape Eden. https://scapeeden.com/wiki/problems/sterilising-a-tank-after-disease
Plain link
https://scapeeden.com/wiki/problems/sterilising-a-tank-after-disease
Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.
