Wiki
Algae

Algae everywhere even though you dose fertiliser

Also calledalgae everywherealgae with zero nitratescan't get rid of algaealgae in a high-tech tankalgae after adding more fertiliseralgae with CO2 and high light

Several kinds of algae at once in a tank that gets fertiliser, and often CO₂ and strong light too. It does not harm fish, but it means light, CO₂, nutrients and water flow are out of step, so fix the balance this week.

How urgentFix this week

Not an emergency, but it gets worse if left.

What you see

  • More than one algae at once, such as hair, staghorn, brush or green spot
  • New growth is covered again soon after you clean it off
  • Plants grow slowly, or show pale, yellow or holey leaves even though you dose
  • Algae is worst where flow is weakest or on old, tired leaves
  • A nitrate or phosphate test reads close to zero

Could it be something else?

  • Slow growth from low CO₂: Slow growth with little algae points to CO₂, not a wider imbalance
  • High nitrate: High nitrate is a reading you can test for; this guide is for algae even when readings look fine
  • Brown algae (diatoms): A brown film in the first weeks of a new tank usually fades as the tank settles

Why it happens

  1. CO₂ too low or not steadyStrong light needs plenty of CO₂. If CO₂ starts late, runs out or swings through the day, plants cannot use the light and algae takes over.
  2. Weak water flowPoor circulation leaves some plants short of CO₂ and nutrients even when you add them, and algae settles in those spots.
  3. A nutrient running outDosing does not prove plants have enough. When phosphate runs out, green spot algae can take hold, and starved plants can leak ammonia, which can trigger algae.
  4. Too much light for what plants can useLight that is too bright or on for too long gives algae the edge. Raise light only when CO₂ and nutrients are raised with it.
  5. Dead and dying plant matterPlants that are starved or dying can leak ammonia, which can trigger algae, so a tank that is dosed well can still grow algae.
Step by step

Fix it now

Safety first: if a step uses a medicine, treatment or salt, follow the product label and never go above the labelled dose. Check the label for animals it can harm, such as shrimp, snails and scaleless fish, and for whether to remove carbon. If you are unsure, or animals keep dying, ask an aquatic vet.

  1. Remove as much algae as you can by hand, and trim dead or badly covered leaves out of the tank
  2. Check that CO₂ is steady: have it reach full strength before the light comes on, and use a drop checker to see that it holds through the light period
  3. Point the filter outlet or add a small pump so water reaches every corner, including the rear and the substrate
  4. Test nitrate and phosphate. If one reads zero, bring it back into a steady range instead of cutting fertiliser further
  5. Shorten the light period or turn the light down until plants grow steadily without new algae
  6. Do larger weekly water changes, about a third to a half in a high-light CO₂ tank, so nutrients stay steady and waste does not build up
  7. Change one thing at a time and give it a week or two, so you can see what worked

Stop it coming back

  • Keep light, CO₂ and nutrients in balance: raise CO₂ and fertiliser together whenever you raise the light
  • Keep CO₂ steady from day to day
  • Fill the tank with healthy, fast-growing plants and trim dead leaves often
  • Keep water moving through the whole tank
  • Dose regularly in small amounts rather than rarely in big ones

Common questions

Why do I have algae when I dose fertiliser every day?
Fertiliser alone does not stop algae. Plants need enough light, CO₂ and flow to use it, and algae grows if any one of them is out of balance. Check CO₂ and flow first.
Can I get algae with zero nitrates?
Yes. When phosphate or nitrate runs out, plants starve and some algae, such as green spot algae, can take over. Bring the nutrient back to a steady level rather than letting it run to zero.
Should I stop fertilising to starve the algae?
No. Cutting nutrients usually starves the plants first, and weak plants invite more algae. Fix the balance instead of removing the food.
I have CO₂ and strong light but relentless algae. What should I check first?
Check that CO₂ is steady through the light period and that flow reaches the whole tank. Then look at light strength and hours, and remove dying leaves.
Scape Eden community

Still stuck?

Describe the problem and share a photo in the WhatsApp community group. Other keepers can often spot what is wrong.

Sources

  1. GWAPA: Algae in the Planted Aquarium
  2. Practical Fishkeeping: Algae prevention in your planted tank

How we made this

Written with AI assistance from the sources listed here and checked against them (September 2026). Not yet reviewed by an expert. Report a mistake · How we write and check pages

Cite this page

Copy a ready-made line to credit this page in your own writing.

Citation

Scape Eden. “Algae despite fertiliser: why it keeps coming back”. Scape Eden aquarium wiki, updated October 15, 2026. https://scapeeden.com/wiki/problems/algae-despite-fertilising

Reference style (APA)

Scape Eden. (2026, October 15). Algae despite fertiliser: why it keeps coming back. Scape Eden. https://scapeeden.com/wiki/problems/algae-despite-fertilising

Plain link

https://scapeeden.com/wiki/problems/algae-despite-fertilising

Text and data compiled by Scape Eden are free to reuse under CC BY 4.0 with attribution (credit Scape Eden and link to this page). Photos keep their own credited licences. Records are AI-assisted drafts with cited sources: see how we write and check this.